I installed my Cyber Grey Badges on my 2013 GS, MANUAL.
Just a heads up to those installing on a manual, due to the presence of the dry sump.
I personally would first start with the drivers side to build your confidence. The drivers side install will only take a couple of minutes to do.
The passenger side however is a totally different beast. After following the removal instructions in this link: https://www.corvetteforum.com/c6-cor...r-emblems.html
You will have to get your hand between the plastic shroud just behind the gills so that you can actually see your hand through the gills. You should be able to pass the nuts that you remove from your right hand that is inside the fender to your left hand through one of the gills. I used a 10mm closed end wrench to remove the nuts from this side. I rested the box end of wrench over the screw tip and used it as a guide so that I always knew where the wrench was in relationship to the nut.
Totally doable but patience is your friend since you''s a separate element as animating opacity is faster than rgba(). -->